Reinstalling the Mast

After the week of work was completed on Cinderella’s mast, we (me especially) were ready to put it back in, and get on with life… Or should I say more boat projects…

Ava and I finished the last task remaining late Friday night in the cold rain. We worked partially under the headlights of Sabbie (Ava’s great little Saab), and used the car as refuge to warm up. Unfortunately, 10 minutes of headlights with no engine charging her batteries was a little rough on ol’ Saabie, and we were thankful of her manual transmission when I was pumping my legs pushing her up to speed.

Ava learn how to push start a car that night, and I was hoping it wasn’t an omen of what was to come.

THE MAST WAS READY TO GO IN!!

Unfortunately, we were unable to schedule the crane to put the mast back in that week, so we would have to schedule an afternoon lift the following week (around my work schedule). That eventually was pushed back to an early lift the following Friday due to a mixup at Canal Boatyard. Even with the mixup, I would recommend them without question, they are in close proximity to our slip, and the guys really know what they are doing.

It was Saturday, and the mast work was done. All that was left to do was to have the yard put the mast back in.

How exactly does one reinstall a mast again? More importantly, why was in not until now that the question popped into my head?

After a brief moment of doubt, I realized that the process is done all the time, all around the world, surely I could figure it out.

I started with google “How to reinstall a sailboat mast.”

It seemed simple enough, have the crane operator lower the mast back into place while I guide the mast back onto its step. Once on the step, attach the forestay (rod going to the front of the boat) followed by the backstay (rod going to the back of the boat) and then the shrouds (rods going to the sides of the boat).

How hard could it be? It turns out, not very hard at all!

Mast prepared to go back into Cinderella

The mast was back in and we had it stabilized in no time. All that remained was to motor back to our slip where we could put the final tension on the rig whenever the weather looks better.

That is where things will get interesting.

The goal of the day was to get the mast back into Cinderella and get her home. We want to avoid any fees associated with keeping the mast in the yard.

Goal accomplished

The rig is back in Cinderella, but we still can’t sail her. This isn’t good because I am itching to go out and sail worse than ever.

Swiftsure is only a couple months away and there is still much to do. We have a hole in the deck around the mast that needs to be filled and two turnbuckles that we need to replace before we can tension the rig and finally put the sails back up.

Mast reinstalled into boat
Arrow
Arrow
Slider

Follow along next time as we apply spartite, replace turnbuckles, and tension Cinderella’s rig.

Leave a Reply

Your email address will not be published. Required fields are marked *